Troy-Bilt weed eaters are supplied to trim grass and weeds that grow approximately objects that the lawn mower cannot obtain to. A spool that has cable wound up around it promptly spins and also cuts the grass and weeds. The cable gradually erodes as soon as cutting her weeds and it will at some point run out. You will certainly then have to replace the north spool through a full spool on your Troy-Bilt weed eater to save trimming the grass and weeds.

You are watching: Troy bilt weed eater spool replacement


Disconnect the spark plug cable from her weed eater to protect against the weed eater from starting up once you space replacing the spool.

Grasp the bang knob and turn that counterclockwise. The bang knob is the knob that enables you come feed more cable out by bumping the weed eater right into the ground.


Troy-Bilt weed eaters are provided to trim grass and weeds that grow around objects that the lawn mower cannot acquire to.

Remove the bump knob, together with the spring and foam seal.

Grasp the empty inner reel and remove that from the outer reel by pulling it right off.

Cut turn off the plastic wrap roughly your brand-new inner spool. Go slow so the cable doesn"t quickly unwind from the reel.

Feed the cable end from the inner spool into the eyelets top top the outer spool. Store the remainder that the cable tight on the inner spool.

Locate the arrow and also push the inside spool on to the outer spool v the arrowhead side facing toward the outer spool.


eliminate the bang knob, together with the spring and also foam seal. Feeding the cable ends from the inner spool right into the eyelets ~ above the external spool.

Install the foam seal, spring and bump knob in the exact same manner together they come off. Rotate the bump knob clockwise to lock every little thing into place.

Grab the finish of every cable and also give the a firm tug. This will certainly release the cable indigenous the holding slots on the inner spool.

Place the spark plug wire back on to the spark plug.

See more: Man Gets Worst Possible News On Pawn Stars, List Of Pawn Stars Episodes

Restring A Troy-bilt Weed Eater

With the trimmer turned off, twisted the inside spool counterclockwise come align that arrows through the arrows the outer spool. Through the stress and anxiety released, remove any leftover heat by pulling on it. Cut a piece of replacement line 10 feet long. Push one finish of the line with the eyelet top top the side of the external spool, and also pass it through the heat loading feet on the inside spool. The line will emerge near the bump button. Usage the various other eyelet top top the external spool this time. Periodically, prevent winding and tug ~ above both lines so the 1 or 2 inch unwind indigenous the spool. This will store the line from jamming. Continue until all the heat is on the spool except for 4 inches. Twisted the within spool clockwise come lock the line in place. Eliminate the inner spool native the external spool. With the arrow side up on the pre-wound spool, insert the lines right into the eyelets of the external spool, and also then on slide the pre-wound spool right into the outer spool.


install the foam seal, spring and bump knob in the very same manner as they came off. V the arrow side increase on the pre-wound spool, insert the lines right into the eyelets that the outer spool, and then slide the pre-wound spool right into the outer spool.