*



You are watching: Body control module pontiac grand am

*
*
*

*
 
*
dearteassociazione.org Forum > GAGT - technological - sponsored by www.MilzyMotorSports.com> technical Q&A
*
Body control Module Location
User Name
Remember Me?
Password

*

*
*

You meam BCM. Ns think the BCM is over your feet as soon as sitting in the passenger seat?Atleast thats were it was as soon as I disabled mine DRLs and ALC on mine "00, or possibly that was the PCM.
Yeah BCM !!!! anyway uncovered it took it out AFTER disconnecting the battery. A couple of of the pins top top the facility plug the end side had corrosion on them none real bad, but I cleaned them with sand paper, sprayed through circuit cleaner then used dielectric grease come the connectors come prevent any further corrosion.


See more: Where Is Mako Island Moon Pool Located, Is Mako Island A Real Place In Australia

dielectric grease probably is not necessary. You need to be careful with the stuff that you don"t use also much and get the in between the contacts due to the fact that it is electrically conductive after all. You could accidentally allow an electric signal jump between two contacts and also then the BCM could break down or even short circuit.Sanding the contact on the plug and also cleaning them through an electrical call cleaner should be sufficient. Any further corrosion have to take a lengthy time to occur unless you have actually a moisture trouble down there. The happens sometimes when civilization get a leak right into the interior from the HVAC air intake at the bottom that the windshield. The air comes in right behind the dash over there on the passenger side
*
and sometimes that reasons corrosion on the BCM and the fan and also fan rate resistor. Make certain you don"t have any kind of leaks and your carpet is remaining dry and also it shouldn"t be a problem.