Your emergency brake is much more important than you could think. Below is how to change your emergency brake on her Ford F-150 or at sight Duty.

You are watching: 2004 ford f150 parking brake diagram


This article uses to the Ford F-150 (2004-2014) and F-250 supervisor Duty (2005-2014).

If her emergency brake isn’t working correctly or is just plain worn out, this aren"t difficult fixes. This repair will take girlfriend the better part of one afternoon. Because that those that are rather mechanically inclined, it need to only take an hour or two.

*


Materials Needed4mm retainer pinBrake lubricantSocket/wrench setPhillips head screwdriverEmergency brake kitJack and 2 jack standsTire ironRubber mallet

Step 1 - Prepare the truck

Block the front wheels so the van can’t roll in any type of direction.Loosen the lug nuts ~ above the behind wheels.Using the jack, advanced the rear finish of the truck enough to get the jack stand underneath the behind axle, and also remove the behind wheel on each side.
*
Figure 1. Raise the truck.

(Related Article: just how to readjust a tires - dearteassociazione.org)

Step 2 - inside the truck

Place her truck in neutral.Remove left A-pillar reduced trim dashboard (pull earlier and it will certainly unclip itself).Have one assistant pull on the intermediate parking brake cable until the parking brake rotating sector manage stops.While the assistant is holding the cable, insert the 4mm retaining pin to relax the parking brake cable stress (as displayed in number 2 below).
*
Figure 2. Relax the parking brake cable tension.

Step 3 - in ~ the behind axle

Disconnect the parking brake cable in ~ the cable-to-cable union using the proper sized wrench or socket.Remove the behind brake disc.
*
Figure 3. Rear brake disc.Remove the brake shoe adjuster screw and brake shoes adjuster screw spring making use of the Phillips head screwdriver.Remove both brake shoe organize down springs, pins, and finally the brake shoe retracting spring.Remove the brake shoe.
*
Figure 4. Spring and also shoe locations.Using the brake lubricant, lubricate the new parking brake shoes where they will certainly make contact with the wear pad.Install the new shoe and ensure the it is focused on the hub.
*
Figure 5. New shoe installed.

See more: Complete Guide To " The Haunting Of Hill House Cliff Notes, The Haunting Of Hill House Summary & Study Guide

Step 4 - Finishing up

Re-install all gotten rid of screws, springs, and also pins in the turning back order they came off.Using the emergency brake shoes adjuster wheel, readjust the parking brake shoe clearance come .66mm.Repeat procedure for the opposite side of the truck.Reattach parking brake cables at the cable-to-cable unions.Remove the 4mm retaining pin.Reinstall the trim panel.Reinstall the wheels.Test the parking brake to ensure the works. You can test easily by parking on one incline, setting the brake, and also then putting the truck in neutral. If there is no roll, the parking brake is collection correctly. If the truck rolls, you may need to inspect the parking brake shoes clearance again.

Related Discussion and also Site