Hello, Here is a overview to help you action by step with instructions in the diagrams listed below to show you just how on your automobile (below)https://www.dearteassociazione.org/articles/crankshaft-angle-sensor-replacementCheck the end the diagrams (Below). You re welcome let us understand if you need anything rather to get the problem fixed.


You are watching: 06 pt cruiser crank sensor location

*

*

*

*

*

I require tire pickled in salt on the wires to his crankshaft sensor I had to put a big tail on should make sure I'm right on color.
i attached a connector diagram and the wiring diagram because that the crank sensor for you come review.https://www.dearteassociazione.org/articles/how-to-check-wiringThe colors and locations are marked.https://www.dearteassociazione.org/articles/how-a-crank-shaft-angle-sensor-workshttps://www.dearteassociazione.org/articles/crankshaft-angle-sensor-replacementRoy
because that the gas engine, it's in the front, appropriate under the starter motor. It has actually three wires in the connector.
It will crank, yet it will not stay cranked. Put it ~ above a tester crankshaft place sensor. I require to know where the is located?
Hello, right here is a guide to display you what you space in for and a diagram below to display you on your car:https://www.dearteassociazione.org/articles/crankshaft-angle-sensor-replacementCheck the end the diagrams (below). You re welcome let us know if you require anything else to get the problem fixed.
Engine light come on, vehicle sputters, diagonistic machine says it's crankshaft position sensor, is that difficult to replace? and where is the on the engine?
that is on the appropriate side that the engine block use photo included. I do not know how tough it will be to get to, together it go not give me any kind of time on instead of it. Inspect out the diagrams (Below). You re welcome let us recognize what happens.
many thanks for the ar of the camshaft place sensor. I have been steering for about two weeks through the same error code, but the power is no't for this reason terrible. MPG's have actually not adjusted (around 20-28), but have only shed some smoothness in acceleration. Can any kind of damage be excellent if I carry out not readjust the sensor? does the error code typical that over there is miscellaneous wrong through the camshaft?Thanks for her advice. Joe
The PCM look because that the crank and cam sensors to sync the injectors through the shoot order. Might I indicate replacing the sensor as shortly as possible. (It is the sensor and not the camshaft )
I followed your advice, ordered on the internet a brand-new CPS, mounted it in fifty percent an hour, and also all codes to be cleared. The PT runs an excellent now! thanks for everyone's help. Joe


See more: What Colors Do You Mix To Make Olive Green Paint, Olive Green Meaning, Combinations And Hex Code

*

The crankshaft position sensor is in the prior of the engine block simply under the starter motor.Removal:1.Disconnect the an unfavorable battery cable. 2.Raise vehicle and support.3.Remove the structure collar, describe the engine, structure collar removal and also Installation. 4.Unlock and also disconnect the electrical connector come the crankshaft position sensor. 5.Remove the crankshaft position sensor bolt.6.Remove the sensor.Installation - 2.0/2.4/2.4L Turbo: 1.Check o-ring for damage and also lubricate the o-ring with engine oil before installing sensor. 2.Use a twisting motion when installing the sensor. 3.Install and also tighten the crankshaft position sensor bolt and also tighten to 9 Nm (80 15 in. Lbs.) . 4.Connect and lock the electrical connector come the crankshaft place sensor. 5.Install the structural collar, describe the engine, structure collar removal and also installation. 6.Lower vehicle. 7.Connect the negative battery cable.